|
Super Stock &
Pro Stock Component Pulling Chassis |
|
Mild Steel Tube Chassis with complete front-end
with Aluminum hubs, rack & pinion installed, weight racks SLHD or
SQHD rear-end with gear ratios of your choice & fully needled,
Franklin planetaries machined with brake rotors, billet calipers,
complete SFI roll cage, wheelie bars. |
$18,900.00 |
|
|
Options |
| Billet Draw Bar (includes pin) |
$295.00 |
|
|
Chromoly chassis & roll cage (saves 60 lbs.) |
$1,500.00 |
 |
| Cast chunk (complete, ready to run) |
$1,750.00 |
|
|
Aluminum chunk (complete, ready to run) |
$2,400.00 |
|
|
Franklin Planetaries machined for brake rotors,
new wheel studs (4 to 1 ratio) |
$2,100.00 |
|
|
Custom brake rotors |
$300.00 |
 |
|
Aluminum covers for planetaries, custom engraved
w/your logo (saves 50 lbs.) |
$375.00 |
 |
|
SQHD Rockwell housing machined down with
plates welded on for Franklin planetaries (can be machined to custom
lengths, add $100.00 for SLHD) |
$1,350.00 |
|
|
Magnesium Franklin planetaries (saves 150 lbs.) |
$4,400.00 |
|
|
Roll cages welded on 1/4" plate |
$1,500.00 |
|
|
Billet Aluminum motor plate, 1 inch thick,
machined to bolt to the back of your block and machined to mount to
your clutch can (add $75.00 for starter mount, thicker plates may
can be fabricated; prices do change with thicker material) |
$550.00 |
 |
|
Pro Stock & Super Farm Chassis |
|
Mild Steel Tube Chassis with complete front-end
with Aluminum hubs, rack & pinion installed, bolts to your Ag
rear-end, any brand |
$5,500.00 |
 |
|
Rocker Arms |
|
7075-T651 Billet Aluminum roller rocker arms for
any color. Machined to install right on the stock shaft, with
or without roller needles on the shaft. Rocker arm machined with
stock ratios or custom ratios for higher lift. |
|
V-8 Massey Rockers, 16 pieces (with .090 or
more lift) |
$1,050.00 |
 |
| IH DT466 Rockers, 12 pieces (stock
ratios or higher) |
$950.00 |
|
|
Note: Rocker arm prices are subject to change
due to increasing cost of materials. |
